Paxar Monarch 9855 Bedienungsanleitung

Monarch 9855 RFID PrinterTC9855RFIDQR Rev. AF 9/05 ©2004 Paxar Americas, Inc. All rights reserved.

6 Die Cut SensorSupplyLever NibsDeflector Supply Roller 5. Adjust the supply holder guides so the sides barely touch the roll. Make sure the supply

7 9. Hold the printhead assembly by the printhead tab while pressing down on the printhead release. 10. Close the printhead by pressing down on th

8 2. Press down on the exit cover tabs to open the exit cover on the front of the printer. 3. Feed the backing paper over the peel bar. 4. Feed the

9 Adjusting the Wide/Narrow Knobs You may need to adjust the two wide/narrow knobs according to the width of your supply. For supply that is more tha

10 Loading Ribbon 1. Open the cover. 2. Unlock the printhead by turning the retaining latch. 3. Lift printhead assembly using the printhead tab unt

11 Adjusting the Print Contrast The print contrast controls the darkness of the printing on your supply. 1. From the Main Menu, select Setup, then

12 When printing on non-RFID supplies, you may also see a label with an overstrike pattern. Do not use that label. When using “overstrike” as the Er

13 Voids Streaks Clearing Jams When you are printing and a jam occurs, the Fault light on the printer's front panel blinks. 1. Turn off the pr

14 Platen Roller 4. Clean the platen roller when you see significant adhesive build-up or a label is wrapped around the platen roller. Use a dry,

15 10. Push on the exit cover firmly to close it. Both latches will click into place. 11. Close the cover and printhead assembly. 12. Turn on the

Each product and program carries a respective written warranty, the only warranty on which the customer can rely. Paxar reserves the right to make ch

16 Problem Action Blank labels print or 750 series errors. Clean supply sensors. Printer does not read or program the RFID tag. See your System Admin

17 704 Printer has not sensed a supply mark when expected or is out of supplies. Press Escape/Clear and try to continue printing. Change supply. 7

18 751 Printer did not sense a black mark when expected. Press Escape/Clear and try to continue printing. Change supply. 752 Printer sensed a mar

19 Operating Temperatures Direct: 40°F to 104°F (4°C to 40°C) Transfer: 40°F to 95°F (4°C to 35°C) Storage: 15°F to 120°F (-9°C to 49°C) Humidity:

20

RFID Regulatory Compliance This section details the regulatory compliance information specific to the RFID components in your printer. It may not app

Collocation Statement: This device must not be collocated with any other antenna or transmitters. Radio Frequency Interference Requirements - Canada T

1 This Quick Reference contains supply loading and general maintenance procedures. Additional RFID documents are available on the enclosed Monarch T

2 Web Sites with RFID Information Paxar A leader in bar code/RFID printers and supply solutions. www.paxar.com AIM Global The association for Automati

3 Using the Control Panel The control panel has a two-line LCD display, two status lights, and five buttons. The control panel displays error codes/m

4 About RFID Supplies RFID supplies are available in four-inch widths and a variety of lengths. See the table below for the minimum feed lengths, rec

5 Printhead Tab Deflector Tab * Depending on the width of the inter-label gap (space between die cut labels), you may need to increase or decrease th