TC0932OI Rev. AC 12/07 ©2004 Paxar Americas, Inc. a subsidiary of Avery Dennison Corp. All rights reserved.OperatingInstructionsOperatingInstructions2
5. Move tag stop up and down by using your thumb to pull outslightly on the release tab and lift up until it stops.Adjust the tag stop to the length o
9. Use the cut tags as a guide and adjust the guide rails backinto the grooves so that they are barely touching the sides ofthe tag.Step 5 - Set the T
5. Tighten the knob.6. Place the tag weight against the tag stop.7. Print a test batch of 50 tags. The stacker’s LED is on whentags are moving through
3. Turn the belt adjustment knob to the number from the stack.4. Print another test batch of 50 or more. The stacker’s LED ison when tags are moving t
1-10 Getting Started
HOW TO OPERATE 2This chapter describes how to ure-load and change suppliesuempty the stacker trayuclear a tag jamuinstall verifier riser blocksHow to
Re-Loading or Changing SuppliesIf you run out of supplies while printing, the printer display orkeyboard shows a 756 status code.1. Press the Feed but
Stacker Running1. Pick up some of the tags in front of the tag weight.2. Move the tag weight against the stack. Try not to push orcompress the stack.
3. Use the tab to lift the transport. Check for tags.4. Remove the tags.5. Lower the transport.6. Replace the transport lock handle. Make sure it is
TROUBLESHOOTING 3Problem ActionStacker Full or760 Warning StatusCode1. Empty the stacker tray.2. Place the tag weight against the tag stop.3. Press
Each product and program carries a respective written warranty, the only warranty onwhich the customer can rely. Paxar Americas reserves the right to
3-2 Troubleshooting
SPECIFICATIONS AStackerHeight: 14 inches (355.6 mm)Depth: 7.9 inches (201 mm)Base Width: 24 inches (609.6 mm)Tag Bed: 29.6 inches long (752 mm)Weight:
Supplies Thickness: .007 inches (.18 mm) minimum.012 inches (.30 mm) maximumWidths: 1.2 inch (30 mm) minimum 4.0 inches (102 mm) maximumLengths: 1.2 i
Each product and program carries a respective written warranty, the onlywarranty on which the customer can rely. Paxar Americas reserves the right to
TC0932OI Rev. AB 12/04 ©2004 Paxar Americas, Inc. All rights reserved.Monarch932 Stacker
TABLE OF CONTENTSGETTING STARTED. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1Unpackin
ii Table of Contents
GETTING STARTED 1The Monarch® 932 stacker works with a Monarch® 9860printer. The stacker supports backfeed mode on the printer. Thereis no power ON/
Step 1 - Installation for the 9860 Printer1. Locate the screw hole on the stacker mounting plate.2. Attach the adjusting bracket to the stacker mounti
Step 2 - Level the Stacker1. Check the distance between the rollers and the knife. Makesure the rollers are not touching the front of the knife or to
Step 3 - Connect the Power Cord1. Plug the power cord into the stacker’s AC inlet.2. Plug the other end of the power cord into a grounded outlet.Once
Step 4 - Check the Alignment1. Load supply in the printer. For more information aboutloading supply, refer to the printer’s Operator’s Handbook orQui
Kommentare zu diesen Handbüchern